DTM 3000
"DTM" Acrylic Enamel is an interior/exterior 100% acrylic high gloss enamel. It is extremely durable, corrosion and chemical resistant, suitable for commercial, industrial, and residential use.
PRODUCT ADVANTAGES
- High Gloss
- Non-yellowing
- High Durability
- Fast Drying
- Low VOC
- Use on Prepared Metal .
USES
For interior and exterior surfaces, steel, galvanized metal, aluminum, masonry, and wood.
SURFACE PREPARATION
All surfaces must be cleaned by removing dirt, oil, wax and loose or scaling paint. Dull glossy surfaces with sandpaper or steelwool. Rusting surfaces must be cleaned of loose rust by wire brushing or sand blasting. Prime with "DTM" primer for maximum corrosion resistance.
APPLICATION
May be applied by brush, roller or spray, Stir material thoroughly before using. Paint at temperature between 50 degrees F and 95 degrees F. Allow 4 to 6 hours before recoating. Dampness and humidity will directly effect drying time. Clean equipment and area with soap and water.
PHYSICAL PROPERTIES
| COLORS: | White / May be tinted to 1200 custom colors |
| VEHICLE TYPE: | 100% Acrylic |
| GLOSS: | 75-80 at 60 degrees |
| DENSITY: | 10.19lb/GAL |
| VOL SOLIDS: | 36.40% |
| WEIGHT SOLIDS: | 49.13% |
| P.V.C.: | 19.42% |
| FLASH POINT: | Not Applicable |
| VISCOSITY: | 85-90 KU |
| DRY TIME: | TO TOUCH IN 1 HR TO RECOAT IN 4-6 HRS |
| V.O.C.: | 125 gm/L |
| CLEAN UP SOLVENT: | Water |
AWS Home | Coatings | Contractors | Facility Managers | Architects | Single-Ply
ENERGY STAR® | Products | Application Specs | Case Studies | Warranties
Photo Gallery | Links | Site Map | Contact Us
All content Copyright © 2004-2008 American WeatherStar
