Acrylic Wall Coat 2000
WeatherStar Acrylic Wall Coat 2000 (AWC 2000) is an acrylic wall coating, flat in finish, that provides excellent flexibility, durability, and weather resistance. The AWC 2000 is suitable for many wall substrates including precast, or poured-in-place concrete, block, and stucco.
BENEFITS
AWC 2000 is designed to form a long lasting durable elastomeric finish that will protect exterior walls from wind driven rain and harmful UV rays.
PRODUCT COLORS
Custom colors available.
APPLICATION
All surfaces to be coated must be clean, dry and free of any oil, grease or dirt. Power washing is recommended. Any existing coating must be checked for good adhesion. Before application, any loosely adhered coating must be removed and bare surfaces must be prepared, cleaned and checked for compatibility. Apply at temperatures between 55 degrees and 110 degrees. Thinning is not required or recomended.
|
Brush:
|
 |
Use a nylon or polyester brush. Do not over-brush as this can cause pin holes and air bubbles. |
|
Roller:
|
Use a 1⁄2" to 11⁄2" nap synthetic roller cover. Do not roll too rapidly as this can cause pin holes or air bubbles. |
|
|
Spray:
|
Airless Pressure, minimum 2500 psi Tip, minimum .321" |
|
| The substrate and its condition will determine the application procedure. |
||
|
Priming:
|
After cleaning the surface thoroughly, prime any new, bare surface with Acrylic Clear Primer – 9000. |
|
| For repainting, Acrylic Clear Primer – 9000 may be used as the primer. | ||
CLEAN UP
Clean all equipment with warm water and soap.
PHYSICAL PROPERTIES
| Two coat system, brush, roller, or spray applied, coverage per coat: | 115-160 sq ft/gal 10 - 14 mils wet; 4.0 - 6.0 mils dry |
| Can be applied up to 20 mils wet. Coverage will vary with the substrate and the texture. |
|
| Flash Point: | N/A |
| Finish: Flat | 0-10 units @ 85° |
| Vehicle Type: | Acrylic |
| VOC (less exempt solvents): | 95 g/L; 0.79 lb/gal |
| Volume Solids: | 42 ± 2% |
| Weight Solids: | 59 ± 2% |
| Weight per Gallon: | 11.8 lb |
SPECIFICATIONS
| Description | Test Method | Results |
| Elongation: | ASTM D2370 | 325% |
| Tensile Strength: | ASTM D2370 | 340 psi |
| Freeze - Thaw Resistance: | ASTM D2243 | Pass |
| Low Temperature Flexibility: | ASTM D522 - Method B @ 10°F | Pass |
AWS Home | Coatings | Contractors | Facility Managers | Architects | Single-Ply
ENERGY STAR® | Products | Application Specs | Case Studies | Warranties
Photo Gallery | Links | Site Map | Contact Us
All content Copyright © 2004-2008 American WeatherStar
