DESCRIPTION
AWS Fibered Aluminum Roof Coating is formulated using quality-oxidized asphalt, fine grade leafing aluminum pigment with polyethylene fibers. Formulated to provide excellent suspension and maximum reflectivity. The superior U.V. resistance of AWS Fibered Aluminum Roof Coating gives an extremely durable roof coating. Meets ASTM2824
BASIC USE
AWS Fibered Aluminum Roof Coating will provide a highly reflective weatherproofing barrier over metal, modified bitumen, and built up roofs. Other surfaces should be tested for adhesion before coating.
LIMITATIONS
Do not apply below 50°F or when rain is forecast. Applications during periods of low temperature will extend dry time. Allow 4 -6 hours for coating to dry prior to being subjected to rain, heavy dew or temperatures below 50°F.
SURFACE PREPARATION
Surface must be power washed using a detergent to remove dirt, loose coating, excessive chalk, and other foreign matter, which will prevent proper adhesion. Prime rusted metal surfaces before coating. Surface must be dry prior to coating.
IMPORTANT: AWS Aluminum Roof Coating is designed for POSITIVE drainage. Areas that pond water need corrective measures to eliminate the ponding.
APPLICATION
Apply with a soft brush, roller or airless spray. AWS Fibered Aluminum Roof Coating applied at 2.25 gallons (36 wet mils) per square, provides a 16 mil dry film coating. This product requires mixing before and during application to insure uniformity of the coating. DO NOT THIN.
WARRANTY
This product is manufactured of good materials and by competent workmen. Seller and manufacturer’s only obligations shall be to replace such quantity of product proved to be defective. Neither seller nor manufacturer shall be liable for any injury, loss or damage, direct or consequential, arising from the use or the inability to use the product for his/her intended use; and user assumes all risk and liability.
TECHNICAL DATA
| Vehicle Base: |
Asphalt |
| Weight per Gallon: |
9.2 lbs |
| Solids by Weight (ASTM 2369): |
62 ± 2% |
| Solids by Volume: |
45% ± 2% |
| Aluminum Paste Content: |
15% |
| Viscosity @ 77°F: |
120 ± 5KU |
| 1000 Hrs. Accelerated Weathering: |
No Cracking or Checking |
| Dry Film Thickness: |
7.2 mils
(@1 gal./100 sq. ft. less surface absorption) |
| Reflectivity: |
63% |
| Therm. Emit: |
45% |
| VOC: |
<425g/l |
| Specific Gravity: |
1.11 |
| Flash Point: |
105°F |
| Solvent: |
Mineral Spirits |
| Clean Up: |
Mineral Spirits |
Coverage:
Smooth Metal:
Built-Up:
Smooth Mod. Bit: |
2.0 gallons per 100 sq. ft.*
2.5 gallons per 100 sq. ft.*
2.25 gallons per 100 sq. ft.* |
| *Note: Coverage may vary depending on the actual condition of the surface. The coverage rates shown are intended as minimum applicationrecommendations. Over corrugated and irregular surfaces, allow foradditional surface area by multiplying total square feet by 1.15 |
AWS Home | Coatings | Contractors | Facility Managers | Architects | Single-Ply
ENERGY STAR® | Products | Application Specs | Case Studies | Warranties
Photo Gallery | Links | Site Map | Contact Us
All content Copyright © 2004-2008 American WeatherStar
